Induction sealing machine is a non-metallic container sealing operation of special equipment, to enter China since the 1990s, after ten years of development, has been widely used in pesticides, pharmaceuticals, food, cosmetics, lubricants and other industries. According to online information collected, we are presented below:

the classification

In the power device classification: aluminum tube sealing machine, aluminum foil sealing machine transistor.

In inductive head cooling classification: water sealing machine, air sealing machine.

In work Classification: Handheld aluminum foil sealing machine, desktop continuous sealing machine, aluminum foil sealing machine line.

the selection

1, a hand-held aluminum foil sealing machine simple operation, good sealing effect, but production is not high, about 30 messages per minute bottles, large labor intensity. Suitable for small-volume users.

There are manual trigger heating and heating automatically trigger two types of products to choose from.

Manual trigger: a bottle placed beneath the sensor head, press the button to start the machine work to complete the seal. Bottle without aluminum foil operator can not be found, resulting in poor product effluent plant.

Auto: bottle placed beneath the sensor head, the machine automatically detects, if the aluminum foil is automatically triggered by the work, complete sealing; if not foil, effectively preventing the outflow of defective products factory.

2, for a certain volume of production, not production lines with customers, desktop continuous sealing machine is a good choice. Easy operation, good sealing effect, sealing about 150 bottles per minute, the labor intensity greatly eased.

3-line aluminum foil sealing machine for production line, without manual operation After commissioning, the complete liberation of the people from out of the production line, high yield.

select the range of sealing

Sealing machines from different manufacturers are not the same range should be selected according to the sealing range in response to the actual situation of their own products.

select power

The purchase of aluminum foil sealing machine, the power of choice is crucial. Power option small, slow or even closure seal is not strong; power too big election, sealing it touches no problem, but the big horse car waste of resources and money.

Output power and heating time to complete two prerequisites of aluminum foil seal, the two complement each other. That is the desired output power when the heating time is short, the output power required long hours of heating time.

(Another: tablets, granules and other low power requirements for sealing, and sealing agent will need a higher power.)

Cooling

1, air-cooled: air-cooled heat sealing machine fan, fewer external components, cheap, simple operation and maintenance.

2, water-cooled: water sealer to dissipate heat by cooling water circulating pump, to regularly add or replace cooling water. When the northern winter more should be taken to prevent the cooling water from freezing. Water-cooled machine induction coil head usually with copper production, small internal resistance, in the same external power driven to achieve higher efficiencies.

power device analysis

1, tube sealing machine: because of their size, power consumption, short life, power and other shortcomings need to preheat has basically been replaced by transistors. But tube load capacity, superior linearity performance transistors, there are still a small number of manufacturers in the production.

2, transistor sealer: small size, low power consumption, long life, start to work, easy to maintain.

The difference between seven and imported machine-made machine

1, imported machines: beautiful appearance, reasonable design, sophisticated materials, low failure rate. But higher prices, maintenance inconvenience.

2, domestic machine: After years of development, maturing domestic sealing machine, machine performance gap is not imported, the price is reasonable, easy maintenance and timely.

after-sales service

1, the warranty period is now fierce competition in the market, some small factories or workshops can only rely on price to hit the market, shoddy work, the warranty period is generally three months, basically no more than six months. So the best choice for powerful and reputable companies to buy regular.

2, parts prices in warranty repairs are generally (except non-normal use caused) free, but the warranty period is different, some plants rely on low-cost machines selling premium services to profit. So before buying equipment to understand clearly will not suffer.